Cant Initialise (enclosure mode) LG Nas N2B1

[AlexHaden]

Hi All,

I have a LG NAS (N2B1), that has been sitting on my shelf since i upgraded to the HP MicroSever.

I have dusted it off to give to my Dad but for the life of me, i cannot get the thing to enter Enclosure Mode (to initialise the 1TB drive i have put in for him)

I have tried the usual Hold left/right and press power and it should enter Enclosure mode (it doesnt, it just says Nas is Netboot......)

I have tried the Power button while holding the S button down. It just sits at NAS booting till i take my finger off the button and i then get Nas Boot Fail!

Just cant figure it out! Any help would be appreciated!

Thanks

[Einzigartig2]

I suffer the same problem.

Looking forward to any solutions!

[Einzigartig2]

Hello again,

Maybe this helps.

I will try it at home

http://lgknowledgebase.com/kb/index....y&EntryID=6513

Besides that: To enter netboot, you have to hold the buttons arrow left an arrow right down, while starting the system.


Gesendet von meinem GT-N8000 mit Tapatalk 2