How to check LAN Speed / connection

[Cloedu]

Hi Forum

How can i check the LAN connections, if the speed is 100 oder 1000 bit/s? I couldnt find any page showing this information.
=> using stock or Merlins Firmware

Claude

[joegreat]

Originally Posted by Cloedu

How can i check the LAN connections, if the speed is 100 oder 1000 bit/s? I couldnt find any page showing this information.
=> using stock or Merlins Firmware

Hi Claude,

Try this command on the telnet interface: robocfg show
You should get a output like similare link this one:

Switch: enabled gigabit
Port 0: 1000FD enabled stp: none vlan: 2 jumbo: on mac: xx:yy:zz:aa:bb:cc
Port 1: 1000FD enabled stp: none vlan: 1 jumbo: on mac: xx:yy:zz:aa:bb:cc
Port 2: DOWN enabled stp: none vlan: 1 jumbo: on mac: xx:yy:zz:aa:bb:cc
Port 3: 100FD enabled stp: none vlan: 1 jumbo: on mac: xx:yy:zz:aa:bb:cc
Port 4: 1000FD enabled stp: none vlan: 1 jumbo: on mac: xx:yy:zz:aa:bb:cc
Port 8: 1000FD enabled stp: none vlan: 1 jumbo: off mac: xx:yy:zz:aa:bb:cc
VLANs: BCM53115 enabled mac_check mac_hash
1: vlan1: 1 2 3 4 8t
2: vlan2: 0 8u

In my case everything is Gigabit, expect the direct attached printer.

With kind regards
Joe

[bz2]

Feture req. in RMerlin

http://forums.smallnetbuilder.com/showthread.php?t=9401